Club100💪||Betterlife||The Engineer's Room- Simulation Of Wiring System , Safety Meeting And The Use Of Cathode Ray Oscilloscope To Generate Waveforms ||01-06-2022||club100💪
Good afternoon steemians. I hope everyone is fine . Today I will like to share with you the activities I performed.
I set off from the house at 6:00 am and got to the work place at 6:50 am. I had to led safety toolbox meeting on behalf of a colleague who has been sick for some days now. Though I did not prepare because the information came in late but I did my best to make the meeting interactive. Everyone contributed or shared their Knowledge which made the meeting an interesting one. The topic I discussed with my colleagues is "compressed gas cylinders defective and power tools". Safety is highly prioritised and zero harm at the working site is a must, hence everyone is endeavor to be attentive and comply with all the safe act and do away with acts normally called unsafe act in order to prevent accident.
Compressed gas must be secured, chained or straps at the upper part of the cylinder with safety valve installed. It might be kept in upright position, labeled with the content in the cylinder. Cylinders should not be rolled and bumped violently against each other. Before regulators are attached, dust and dirt must be cleared. Also defective tools must not be used, tools must be inspected before using it. The application and limitations of power tools must be known before using it. Power tools must not be used in wet or damp areas, it should be double insulated. After the meeting, I took my breakfast and then went to the training room where we normally have our training session.
Today we wired a circuit on a test board, it is all about a system to control the flow of water in the mine process plant. The circuit was simulated to know its functionality. A contactor which is used to start the motor was installed, relays and circuit protective device was also installed. There is an alarm system which beeps when the water level is low, though we already have a system like this but this is an improvement of it. Everything worked perfectly after series of testing it.
Simulation of wired system on test board to control the flow of water at the mine plant site |
---|
After the simulation of the wiring system, we continued with the use of the Oscilloscope to generate sine wave, square wave, direct current and saw-tooth wave. Different frequencies were set with different period. At each case, the Oscilloscope was use to generate the waveform.The amplitude, maximum voltage, peak to peak voltage were calculated from the out come. It is nice experience to have a practical feel of what we have learnt in theory.
Using Oscilloscope to generate different type of waveforms |
---|
I went for lunch at 11:45 am. I didn't eat much, I ate most of the vegetables and fruits. I returned from the canteen and had a good time with a friend. We discussed a lot about our personal life until lunch time was over.
@anas354 with a friend |
---|
This brings to the end of my day. Thank you for your endless love. I dully appreciate your support.
My regards
Bro, thank you for sharing with us
You are always welcome
Thanks for your sharing your diary with us, for your food you ate I make a preparation of it today morning