HOW TO RIND BLACK DOFF WITH PYLOX

Today I am going to share my experiment, painting a black doff helmet with pilox paint, a helmet that I use branded TRX-3.

Prepare the following ingredients:

• The sandpaper is smooth and rough
• BLACK FLAT 109A Paint
• Flowing water

How to paint:

Remove all attributes and helmet accessories, such as glass and foam.

Begin sandpaper helmet with coarse sandpaper until the paint on the helmet begins to slip off, sandpaper until evenly spread to the sidelines of the helmet. After flattening, sandpaper again with fine sandpaper. It aims for the results are not shaped sandpaper, in need of extra patience when sanding because it is quite draining.

Do not forget to flush with water while sandpaper to minimize the existing dust, and rinse thoroughly after the sanding process is complete.

Here is a picture after finish in sandpaper and ready in paint.

Wipe with a dry cloth and dry it for about a few minutes to keep the remaining rinse dry, do not let any remaining water. And do not try to clean up the timbulan, because it will make the results in the surrounding part of damaged,

After dry the lid of the helmet that you do not want to color and some parts of the helmet can not be removed as rubber helmets helmets helmets and neck helmets.

Time for painting process

at the time of painting not too close to the object. Keep the distance about 25 - 35 cm, if you can not estimate the distance just use a ruler size 40.

Spray is Pylox with 1 direction, try spraying does not repeat for spraying evenly with the other side.

Paint the surface with a thin but not too thin
Paint can be stacked according to taste usually stack of paint approximately 5x pile.

The way of painting is very simple, just spray thin first paint and wait until 3-5 minutes then spray thin again paint to two so on her.

Here the results of my work with 2 layers, in addition to just for the experiment, pretty much the rest of the paint can be pake ngecat the other.