You are viewing a single comment's thread from:
RE: The first prototype of the 3D gridcoin
Agreed. I was just saying 100 for sake of explaining the code on the back, but if we wanted to we could with a 3D printing service. There's one in my town that charges $0.25 per cm³. So a coin thats 2mm thick, and has a 40mm diameter, would cost $0.625 a coin, and $62.50 for 100 coins, then we'd have to raise funds for the faucet, which would we would have to set up. If we were to do this,I say we do it for a big event. I don't see us running into any problems with the community jumping in to help for a large event.
Great ideas guys! The only problem I see is the distribution process. I'm sure the foundation fund could be used to print those coins. Would love to see this happening!
I wouldn't say the distribution process would be that difficult. If a trusted member of the Gridcoin community is going to a big event to spread the word, then we could order some coins a month or so ahead of time, and mail them to him/her to hand out.