You are viewing a single comment's thread from:

RE: Introduction to 3D parametric modeling - Part I

in #parametric-modeling • 8 years ago

Hello and thank you very much for your reply and appreciation!
I used to work with Inventor, since I've got the certification on that software as well (but not since 2009, I started studying it only in 2014 eheh!). Then, I started learning Fusion 360 and I actually love it. Do you use it?
Thank you again!

8 years ago in #parametric-modeling by
$0.00
    Reply 0

    Coin Marketplace

    STEEM 0.06
    TRX 0.32
    JST 0.061
    BTC 68202.41
    ETH 2059.15
    USDT 1.00
    SBD 0.50